- 7 -
two figures on the right side of the digital display. The duration of the treatment session
can vary from 1 to 60 minutes with the step of 1 minute. If one presses buttons «
+
» or
«
–
» for more than 1 second, the duration of the treatment procedure increases
(decreases) automatically as indicated on the display.
Performing treatment procedure
Membrane surfaces are to be applied to the body covered with a gauze, paper or
cotton towel (for hygienic reasons). Application should be made in zones described in
the treatment scheme.
After the data on indicated in the particular treatment scheme Mode and Duration of
the treatment session is entered and indicated on the display, press and release the button
C
«Start / Stop» (6). When the button is pressed, the apparatus begins to perform the
treatment procedure programmed. One will see blinking of the figures, indicating
duration of the treatment session – this means that timer has started its work. The
changing figures on the display indicate the time, left before the treatment session is
over.
When the apparatus is in work, a continuous sound of changing frequency is to be
produced by vibrating membranes of the vibrophones. During first 5-30 seconds of work,
sonic frequency will be considerably low (30–60Hz). Then it must continuously change
from very low to very high, almost ultra-audible (9000–18000Hz) values and back – from
very high to very lower – in a continues cycle of frequency changing.
Completion of the treatment procedure
When a treatment session is over, the apparatus automatically completes its activity
and after a short break (of 1-2 seconds) enters a status waiting for data entry. The data on
the mode and treatment session duration, indicated on the display, will be still valid for
the treatment procedure already over.
In case of need, a treatment procedure can be discontinued any moment by pressing
and releasing the button
C
«Start / Stop» (6). After this initially programmed parameters
will be indicated on the display.
Automatic switching off of the apparatus
If no buttons were pressed during the time period of more that 60 seconds and the
apparatus was ready for data entry of adjustment, the figures on the display go out and a
point is visible at the place of the Mode parameter indication. One can interrupt this by
pressing any button on the front panel of the apparatus.
In the case if the apparatus was not utilized for the time period of more than 4
minutes, it will automatically choose the status of reduced power consumption. Nothing
is indicated on the digital display. One can interrupt the status of reduced power
consumption by pressing and releasing the button
C
«Start / Stop» (6). After this for a
short period of time the following data will be indicated on the display:
I oo
(status
“Preparation for work”). Then, in 2 seconds, one will see on the display automatically
programmed mode (Mode 1) and duration of the treatment session (20 minutes)
: I 20
.
Now the apparatus is ready for a treatment session with the parameters programmed or
for an adjustment of Mode and Duration parameters in accordance with a particular
treatment scheme.
