TM-RX Receiver
May 2021
Visual Engineering
Video solutions. Integrated
visualengineering.co.uk
Page 30
Basic RF Setup
The following can be used to configure a node to join a Mesh network.
Browse to the
Configuration>Preset>Mesh
tab, the highlighted options are the key points to
consider.
Item
Description
Enable
Tick the Enable checkbox to switch the transmitter on.
Frequency
Type in the frequency to use for the Mesh.
This must be the same for all units.
Channel Bandwidth
Select the bandwidth to use for your Mesh from the drop-down list.
This must be the same for all units.
Mesh ID
Type in a Mesh ID, this must be the same on all units in the Mesh network.
The Mesh ID tells the unit which Mesh it belongs to.
All NETNodes on Mesh ID 1 for example will communicate with each other.
Node ID
Type in a Node ID for each node.
The node ID must be unique in the Mesh network.
Note
: A node can automatically reassign its Node ID at power up
if it finds a conflict with an existing node.
Apply
When the values have been set, click Apply.
The unit will not change its values unless this is done.
