8
D-302756
4. PROGRAMMING
4.1 General Guidance
We recommend programming the PowerMax10-G2 on the work bench before actual installation. Operating power may be
obtained from the backup battery or from the AC power supply.
4.2 Navigation
This mode allows you to customize the control panel and adapt its characteristics and behavior to the requirements of the
particular user. To review the options within the control panel menus, repeatedly press the
or
button, until the
desired option is displayed, then press the
OK
I
button
.
You will mainly use 5 control pushbuttons during the entire programming process:
- to move one step forward in a menu.
- to move one step backward in a menu.
OK
I
-
to enter the relevant menu or confirm data.
- to move one level up in a menu.
- to return to the "OK TO EXIT" state.
The sounds you will hear while programming are:
- Single beep, heard whenever a key is pressed.
- Double beep, indicates automatic return to
the normal operating mode (by timeout).
☺
-
Happy Melody
(- - - –––), indicates successful
completion of an operation.
-
Sad Melody
(–––––), indicates a wrong move
or rejection.
If you enter an invalid installer code 5 times, the keypad will be automatically disabled for 90 seconds and the message
WRONG PASSWORD will be displayed.
4.3 Permissions and User Codes
The PowerMax10-G2 system includes four code levels, as follows:
•
Installer Code:
By using the installer code, the menu enables changing the installer code.
•
Master Installer Code:
By using the master installer code, the menu enables changing both master installer code and
installer code.
•
User Code:
See PowerMax10-G2 User Guide
•
Master User Code:
See PowerMax10-G2 User Guide
Not every system includes a MASTER INSTALLER code. In a system with an INSTALLER code only, the installer can use all
the functions in the system.
The following actions can be done only by using the master installer code:
•
Changing master installer code.
•
Resetting the PowerMax10-G2 parameters to the default parameters,
•
Defining specific communication parameters.
You are expected to use this code only once for gaining initial access, and replace it with a secret code known only to
yourself.
4.3.1 Setting a New Installer Code
To set an installer code, perform the actions that are presented below. When you are instructed to enter code, enter a 4-
digit code.
A. To Set a New Installer Code
1.
Make sure the system is disarmed and then press the
button
repeatedly
until the PowerMax10-G2 display reads
"
INSTALLER MODE
".
2.
When the PowerMax10-G2 display reads
[
INSTALLER MODE
]
,
press
OK
I
.
OK
I
The screen will now prompt you to enter your installer code.
∗
∗
The default Installer Code is
9999.
ENTER CODE:
INSTALLER MODE
READY 00:00
