D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
59
Option settings:
disabled
(default);
cellular
and
PSTN
.
Important:
Only selected communication channels will be used by the system to
report event messages to Monitoring Stations.
If none is selected, the
reporting to monitoring stations will be disabled
.
Note:
When
Cellular
channel is selected then the priorities within he cellular will
be GPRS (IP) channel first, then GSM voice channel and last SMS
channel provided these channels have been enabled in section 3.6.3.
Here you determine whether or not to report events using
PSTN and Cellular
.
Option settings:
disable
(default) and
PSTN & cellular
.
Here you enter the respective 1
st
Account (subscriber) number (11:RCVR 1 ACCOUNT)
that will identify your specific alarm system to the 1
st
Monitoring Station (designated as
RCVR1 or RCV1) and a 2
nd
Account (subscriber) number (12:RCVR 2 ACCOUNT) that
will identify the system to the 2
nd
Monitoring Station (designated as RCVR2 or RCV2).
Each of the Account numbers consists of 6 hexadecimal digits.
Master Installer only
Enter the 1
st
and 2
nd
Account numbers in their corresponding locations. To enter
Hexadecimal digits, use the following table:
Entering Hexadecimal Digits
Digit
0…..9
A
B
C
D
E
F
Keying
0…..9
[#]
[0]
[#]
[1]
[#]
[2]
[#]
[3]
[#]
[4]
[#]
[5]
Master Installer only
The PowerMaster-10 / PowerMaster-30 can be programmed to report the event
messages defined in the Report Events option (option 01) to two Alarm Format
Receivers via PSTN telephone line and/or GSM analog voice channel (if equipped with
GSM module), using standard PSTN alarm formats (i.e. SIA, Contact-ID and Scancom).
The reporting format is defined in the "PSTN Report Format" option (option 41).
Here you enter the two respective telephone numbers of the Alarm Format Receiver 1
located at the 1
st
Monitoring Station (16: PSTN/GSM RCV1) and alarm format Receiver
2 located at the 2
nd
Monitoring Station (17: PSTN/GSM RCV2).
Enter the telephone numbers of alarm format Receiver 1 and Receiver 2 in their
corresponding locations (
including area code
– maximum 16 digits). For further
programming information see the table below.
Note:
If any of the phone numbers programmed herein contain an
area code
identical
to the area code of the PSTN telephone line to which the system is connected, you
should refer to the
option in section 3.6.2.and act as instructed there.
Digit
Keying Digit Significance
A
[#]
[0] The dialer waits 10 seconds or waits for dial tone, whichever comes
first and then dials. Applicable only at the 1
st
digit.
D
[#]
[3] The dialer waits 5 seconds for dial tone and goes on hook if none is
received. Applicable only at the 1
st
digit.
E
[#]
[4] The dialer waits 5 seconds. Applicable only in the middle of the
number.
To
move the cursor
and
clear digits
, use the
"String Editor's"
keys as described in
the table at the end of section 3.6.3.
AREA CODE
17:PSTN/GSM RCV
2
12:RCVR2 ACCOUNT
16:PSTN/GSM RCV
1
11:RCVR1 ACCOUNT
05:DUAL REPORT