48
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
To change the code, enter the new 4-digit of the new Duress code at the position of the
blinking cursor or enter 0000 to disable the duress function and then press
.
Notes:
1. The system does not allow programming a duress code identical to an
existing user code.
2. Duress Code is not applicable in the
UK
.
Previously known as
"NOT ACTIVE"
If no sensor detects movement in interior zones at least once within the defined time
window, an
“inactive alert"
event is initiated.
Here you determine the
time window
for monitoring the
lack of motion
.
Option settings:
disabled
(default);
after
:
3 hours
;
after 6 hours
;
after 12 hours;
after
24 hours
;
after 48 hours
and
after 72 hours.
Here you determine whether the Tamper switch protection of all zones and other
peripheral devices (except the control panel) are Active or Not active.
Previously known as
"TAMPER OPTION"
Option settings:
active
(default) and
not active.
Warning!
: If you select "not active", be aware that no alarm or report will be initiated in
case of tampering with any of the system peripheral devices.
To avoid nuisance reporting in case of short interruptions in the house AC power, the
system reports an AC Fail message only if the AC power does not resume within a pre-
determined time delay. Here you determine the time delay between the occurrence of
AC power failure and the reporting of the trouble event.
Option settings:
after 5 minute
(default)
, after 30 minute
,
after 60 minute
or
after 3
hours.
Note:
To comply with
EN
requirements, the time delay must not exceed 60 min.
Previously known as
"CONFIRM TIME"
If two successive alarm events occur within a specific time window, the system can be
configured to report the second alarm event as a
"confirmed alarm"
(see section 3.6.4
option 61). Here you can activate this feature and set the respective time window.
Option settings:
disable
(default in USA);
in 30 minutes
;
in 45 minutes
;
in 60 minutes
(default); or
in 90 minutes
The PowerMaster-10 / PowerMaster-30 can be configured to provide an “Abort Time”
delay before initiating an alarm that starts upon detection of an event. If the user
disarms the system within the selected abort time, the alarm is aborted (not applicable
to alarms from FIRE, 24H SILENT and EMERGENCY zones). During this time delay,
the buzzer sounds a warning beep but the siren remains inactive and the alarm is not
reported. Here you can activate the feature and select the "Abort Time" interval.
Option settings:
in 00 seconds
(default in USA);
in 15 seconds
;
in 30 seconds
(default);
in 45 seconds
;
in 60 seconds
;
in 2 minutes
;
in 3 minutes
and
in 4 minutes.
Note:
To comply with
UL
or
CP-01
requirements, the abort time must not exceed 45
sec.
The PowerMaster-10 / PowerMaster-30 can be configured to provide a ”Cancel Alarm”
time window that starts upon reporting an alarm to the Monitoring Station. If the user
disarms the system within that "cancel alarm" time, a “cancel alarm” message is sent to
36:CONFIRM AL
ARM
33:
INACTIVE ALRT
35:
AC FAIL
REP
RT
38:CANCEL ALARM
37:ABORT TIME
34:
TAMPER ALARM