Page 9
LGR User Guide and Technical Manual
Confi guration Steps [continued]
5.
On the LiveGear Receiver:
a. Using the LCD on the front panel, press the up arrow to display the WAN
IP address. This IP address needs to be entered in the host address fi eld using
the AirStream touchscreen or Web page.
b. Default Listening Ports are: 4001 for Channel1 or 4002 for Channel.2.
c.
Save
the settings
d. Select the
Status
button to return to the Status screen.
6.
Apply power to the AirStream using power rocker switch on left side. Wait for the
initialization process to complete [approximately 3 minutes]. Ensure that you have
installed fully-charged batteries [or use DC input]. Batteries must be recharged
using an external charger. Allow approximately six minutes for the AirStream to
boot up and optimize the cellular links for broadcast.
a. After approximately 30 seconds, a green screen appears.
b. After approximately 30 more seconds, the green screen disappears.
c. Once 3-6 minutes have elapsed, the Status Touchscreen appears.
7.
On the AirStream transmitter:
a. Check that the Cellular Status screen shows service for the cell modems with
SIM cards installed. Reboot the transmitter if the cellular carriers do not connect.
b. Adjust the Cell Mode [Delay] desired for transmission on the Status
Touchscreen.
c. Once the AirStream is booted and the modems are connected, press
Setup
>
Video/Audio Settings
to begin confi guration.
d. Adjust the Encoder Bitrate Control based on the carrier service available.
e. Select the Video/Audio Option and choose the correct Video Input Resolution,
Audio Mode and Encoding Mode.
f. Be sure that the Stream Output is set to
Modem
for cellular transmission or
wired for Ethernet transmission and press the
Save
button.
g. Select
Back
to return to the Setup Menu.
h. Select
LGR
and set the Host address to the IP address of the confi gured LGR,
then press the
Save
button.
NOTE
:
If you setup a different port number on the LGR, you can change the Port
number on the LGR Touchscreen to match that selected for the receiver.
i. Ensure that you have a secure connection to your video source at the Video
Input BNC connector on the left side of the AirStream transmitter.
j. Select the AirStream’s
Start On Air
button to begin live streaming.
NOTE
:
Disconnect video and wait fi ve seconds before reconnecting when changing
resolutions
.
8. You can view connection status by logging into the LGR Web interface and
selecting
Channel 1
on the dropdown.
