ENGINEERING
GUIDES
Date of last revision: 2.06
TREADMILL.UPPERBDENG.DELUXE.REV1
4
ENG2: DISPLAY TEST MODE
Key
Function
ENTER/ SELECT
All LEDs light up
SPEED UP
Turns on individual LEDs in all the displays in a clockwise motion and the dots in the dot
matrix move up in different colors
SPEED DOWN
Turns on individual LEDs in all the displays in a counter-clockwise motion and the dots in the
dot matrix move down in different colors
STOP
No Function
ELEVATION UP
Shifts 8 across the seven segment display and a column in the dot matrix from Left to Right
ELEVATION DOWN Shifts 8 across the seven segment display and a column in the dot matrix from Right to Left
START
Turns on the Function LEDs one at a time. Continue to press START to test each LED.
ELEVATION 1-9
Displays Elevation number in the LED windows
SPEED 1-9
Displays Speed number in the LED windows
ENG 3: BURN IN MODE
The burn in mode can be used to run tests that require the treadmill to continually run. The program is based on the
5k program. Segment changes will occur, depending on the treadmill configuration. When the system reaches the last
segment, it loops to the first segment. Speed start is at half max. The user can adjust the speed and incline. The program
returns to the preset incline upon segment completion. Keyboard functions are the same as in normal operating mode.
ENG 4: AUTO-CALIBRATION
1. Check configuration in ENG 1 before auto-calibrating treadmill.
2. Press the
“SELECT”
key once.
““AAUUTTOO--CCAALLIIBBRRAATTEE””
will scroll in the dot matrix.
3. Press
“START”
key once to begin Auto-Calibration
4. The treadmill software will look where the elevation stalls to determine the minimum elevation. The software
then automatically backs off to set 0% elevation. The software will then look where the elevation stalls for the
highest point the treadmill elevation will go. The software will automatically back off and set the maximum
elevation, 12% or 15% depending on the treadmill model. Meanwhile the belt is being driven while the
speed is being monitored. As it reaches the minimum, speed 1, 1/2 max, speed 2 and max speed the PWM
is recorded for these targets. The Elevation window displays the Elevation A/D and the number in the upper
right window displays the speed PWM.
6. To look at these numbers after calibration go into engineering mode and go to ENG1; press
“SELECT”
.
7. In P0, SP, P1, SP2, P2 the speed will be displayed. Press
“SELECT”
to read the PWM value.
P4 and P5 represent the elevation values
Deluxe Upper Board: Engineering Guide
