VISIO BW-1210 QW, Руководство пользователя

Страница: 17 / 20

16A
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not
used.
6. Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
Problem Possible Cause Action
Incorrect power cable
connection.
Check the connection of power.
The unit does not work, no light.
Incorrect mains voltage. Measure the mains voltage
on the main connector.
Incorrect DMX cable
connection.
Check DMX connectors and
cables to see if link properly.
Repair or replace damaged wires.
Incorrect address assignment to
the units.
Check the addresses of the units
and the protocol settings.
Unfinished data connection. Insert a terminal plug in the
output jack of the last unit of the
connection.
It has been set up an operating
mode different from the DMX
mode used.
Check the operating mode set up.
The unit does not respond
properly to the DMX control.
Try to use another DMX
controller.