56
Default Value
PI value
This is an axle by axle calibration value that is set when each
axle is calibrated
PI percent
This is another representation of the above item
Serial number
The transducer serial number. This is not currently used
Software ver
Transducer firmware version numbers are shown here
JBox
inclinometers
This is for internal diagnostic use, showing junction box
angles and an asterisk showing the angle currently
being used
Note 1.
This default is stored in the Transducers, not the meter
so defaulting the meter will not affect these figures.
Note 2
. If you wish to decode the serial data from the
scoreboard output you will need to sign an MNDA
(mutual non-disclosure agreement) with SI Onboard.
SI Onboard TruckWeigh™ Manual
Appendix B
Содержание VPG On-Board Weighing SI Onboard TruckWeigh
