EN - 63
Legend ‘70s
– User Manual
Appendix
Error in reading file!
– [DELAY] Led
The system cannot read the selected file. Make sure that the USB flash drive is connected properly and that it is
undamaged.
INTERNAL ERROR #”X”
These error messages are shown when the instrument is switched on, if one or more of its components aren't
working properly. Instead of an ‚X‛ you will see a number, according to the type of device and of error, followed
by the message [Update required] or [Contact service].
If you see the message: "[Update required]", the malfunctioning might be solved by installing the operating
system again (page
). If you still see the same message again after the update, or if it changes to [Contact
service], you need to contact the technical support by writing an email to
indicating the error
message and the number that appears on screen.
Memory is protected!
Programs or Songs cannot be saved and backup files cannot be loaded, because the
Memory Lock
function is
Not recognized as backup file.
The file you are trying to load is not a
Legend ‘70s
compatible backup file.
Restore aborted!
The backup file you are loading is corrupted. Try copying the file again to the USB drive, then repeat the procedure.
Too many update files!
The USB flash drive contains more than one update file. The root folder of the flash drive should contain only
one system update file.
Update Failed. Error #”X”. [Please retry]
The operating system or module update failed. Restart the instrument (switch off, then on again), leaving the
USB drive connected to the port: the instrument will try to update again. If the same error message appears
after the new update, contact the technical support by writing an email to
including the error
message and the number that appears on screen.
Update file not detected!
– 3 blinking leds
No update file was detected in the USB flash drive currently connected to the instrument.
USB charger active
You are trying to update the system despite the fact that the USB [TO DEVICE] port is currently set so as to
power/charge an external device (page
).
USB charger OVERCURRENT [Extract device]
The external device you are trying to charge through the USB [TO DEVICE] port requires too much power. To
avoid malfunctions, the port is deactivated for 10 seconds. Disconnect the device and check that it is
undamaged.
USB flash drive DAMAGED [Extract drive]
The flash drive connected to the USB [TO DEVICE] port is not working properly. To avoid malfunctions, the port
is deactivated for 10 seconds. Disconnect the USB drive and check that it is undamaged.
USB flash drive not detected!
The system does not detect the USB flash drive that is necessary for the current operation. If the correct USB
flash drive is connected to the instrument, disconnect it then connect it again. Also check that the flash drive is
formatted correctly with the FAT32 file system and that it is undamaged.
USB flash drive not detected!
– 3 blinking leds
The system does not detect the USB flash drive that is necessary for the operating system update. If the correct
USB flash drive is connected to the instrument, disconnect it then connect it again.
Wrong backup file!
The backup file you are trying to load is not compatible with the instrument.
Wrong format. Newer software is required
The backup file you are trying to load was generated with an operating system that is more recent than the version
currently running on your instrument. Update the instrument to the latest available operating system version.
Содержание Legend '70s Artist
