Virtuox VPOD, Инструкция по эксплуатации, Страница: 7 / 16

Vpod Instruction Manual
6
inside the battery compartment.
Fig. 3
Cautions!
Be sure to install batteries with correct polarities.
Only use the approved batteries.
Do not use batteries not specified for this unit.
Do not dispose of batteries in fire.
If battery fluid gets on your skin or clothing, rinse with plenty of clean water immediately.
Remove the batteries from this unit when you are not going to use it for a long period of time
(approximately one month).
Do not use batteries of a different type together.
Do not use new and used batteries together.
Dispose of batteries in accordance with the local ordinances and regulations.
2.3 Connect the sensor
Connect the oximeter sensor to the top of the oximeter as shown in Fig. 4. Ensure that the sensor is
firmly plugged in.
Fig. 4
Notice:
The connector is also applied to upload data to Virtuox software for managing data.
CHAPTER 3 Setup before Operation
3.1 Power on the oximeter
Short press the Power button to power the oximeter on.
Notice: To maintain the highest degree of accuracy, it is recommended that the finger and the
oximeter sensor/probe should be kept as still as possible.
3.2 Enter “Setting mode”
Press the function button for about 4 second (extended press), the oximeter will enter into “Setting
mode” and you will find a parameter item which include its title and value on the top right corner of the
display (refer to Fig.5).
After entering the setting mode from the normal screen, continually press Function button, the current
parameter item will be changed sequentially in the following order:
Br(brightness) -->ID(patient’s ID) -->Y(year) -->M(month) -->D(date) -->H(hour) -->m(minute)
-->S(second) --Br(brightness)-->...
Fig.5
Notice: When setting date and time, please don’t insert finger.
b) Save and exit from “Setting mode”
①
Under the “Setting mode”, press “function key (left key)” to select the desired parameter item.
②
Then press “Setting key (right key)” to adjust the value.
Each time when you press the “Setting key (right key)”, current parameter value will be added by 1 unit
sequentially.
Double press the “Setting key (right key)” and the current parameter setting will be added by 10 units
sequentially. All use circular logic.
③
Press “function key (left key)” to select the next desired parameter item. Then redo step
②
to
adjust the value. You can continually redo step
①
to
②
until no parameter’s setting need to be
changed.
④
To finish setup, fleetly press both left and right keys together to confirm . Then the modifications