™
RELOAD INDICATOR LED ACTIVATION
//
When the Spire III Smart Ramp goes up, the Spire III Heads-Up Reload Indicator LEDs on both sides of the
Spire will change their color to Indicate when it's time to reload. Use this setting in conjunction with the Reload
Indicator Alarm to fine tune how you want the Spire III to warn you to reload based on your style of play.
The LEDs are positioned so they are not distracting while shooting, but just out of line of sight so you can see
it with a quick movement of your head. When Reload Indicator is activated the LED colors are:
RED
– if the Reload Indicator is activated: time to reload.
BLUE
– if the Reload Indicator is not activated: your hopper is full.
Setting 1
: Reload Indicator LEDs activate immediately after the Smart Spring Ramp goes up.
Setting 2
: Reload Indicator LEDs activate after the Smart Ramp goes up and the motor spins 5 times
Setting 3
: Reload Indicator LEDs activate after the Smart Spring Ramp goes up and motor spins 10
times.
G-FORCE SENSITIVITY
//
This setting allows you to adjust the sensitivity of the G-force sensor. Setting 1 is the least sensitive and
setting 7 is the most sensitive.
Do not adjust this setting unless there is problem with your Spire III, and you have already removed and
cleaned the Spire Drive and are sure you have good batteries. Generally, you do not need to adjust this
setting at all unless there is a problem.
If the Spire III is spinning too much causing pop-corning, you can lower the sensitivity. Please note, too high
of a sensitivity can cause unwanted pop-corning, and too low of a sensitivity can cause the loader not to
detect shots. It is only recommended to adjust this setting if absolutely needed.
MANUAL
//
PAGE 8
RED
VALUES 1-7
/
Default 4
TEAL
VALUES 1-3
/
Default 1
HEADS-UP
