™
DRIVE PRESSURE
//
The Spire III features a new Automatic Drive Pressure monitoring logic that enables the loader to sense when
to start and stop on its own.
Setting 1: (Default) Auto mode. In this mode, the loader will choose the best setting for current conditions.
Settings 2 – 7: Manual modes. The higher the value the more pressure the Spire Drive needs to feel before it
will stop spinning. Lower numbers will make the Spire Drive stop easier when it feels pressure on the stack.
Do not adjust this setting unless there is problem with your Spire III, and you have already removed and
cleaned the Spire Drive and are sure you have good batteries. If the Spire III stops spinning before the balls
stack is full, you can raise this setting. Too high of a setting can cause unwanted pop corning, and too low of
a setting can cause the Spire III to stop spinning too soon.
A Note on Reballs:
Because Reballs have a high amount of friction, you should not use the default Auto Mote, but turn
the Drive Pressure setting to 4 or higher to ensure the Spire does not stop feeding the Reballs
prematurely.
LED POWER SAVER
//
This setting allows you to turn the LEDs off. This can be useful for example when playing night games or if
you want to conserve power.
Setting 1
: Heads-Up LEDs are on. The LEDs automatically dim occasionally to 40% power when the
loader is idle to conserve battery life.
LED POWER SAVER CONTINUED ON NEXT PAGE
MANUAL
//
PAGE 9
YELLOW
VALUES 1-8
/
Default 1
GREEN
VALUES 1-3
/
Default 1
