INSTRUCTION FOR USE
ENGLISH
25
BRUSH/PAD CLEANING
CAUTION!
It is advisable to use protective gloves when cleaning the brush/pad because there may be sharp debris.
1.
Remove the brush/pad from the machine, as shown in the Use chapter.
2.
Clean and wash the brush/pad with water and detergent.
3.
Check that the brushes/pads are in working condition and not
excessively worn; if necessary replace them.
SOLUTION FILTER CLEANING
1.
Drive the machine a level section of floor.
2.
Ensure that the machine is off and the ignition key (42, Figure 3) has
been removed.
3.
Empty the solution tank or turn off the tap (K, Figure 23)
4.
Remove the transparent cover (D), then remove the filter strainer (E).
Clean and install them on the support (F).
SQUEEGEE CLEANING
NOTE
The squeegee must be clean, and its blades must be
in good conditions in order to get good drying ac-
tion.
CAUTION!
It is advisable to wear protective gloves when clean-
ing the squeegee because there may be sharp debris.
1.
Drive the machine to a level section of floor.
2.
Turn the ignition key (42, Figure 3) to "0".
3.
Lower the squeegee (11, Figure 1) with the squeegee lifting/lowering
handle (39, Figure 2).
4.
Loosen the knobs (C, Figure 24) and remove the squeegee (B).
5.
Disconnect the vacuum hose (A) from the squeegee.
6.
Clean the steel or aluminum squeegee (Figure 25). Clean the
compartments (A) and the hole (B) especially. Check the front blade
(C) and the rear blade (D) for integrity, cuts and tears; if necessary
replace them (see the procedure in the following paragraph).
7.
Assemble the squeegee in the reverse order of disassembly.
NOTE
The filter strainer (E) must be correctly positioned
on the housing (H) of the support (F).
Figure 23
K
H
E
D
E
G
F
Figure 24
Figure 25
C
D
A
B
A
B
C
C
D
A
