INSTRUCTION FOR USE
ENGLISH
18
ADJUSTING THE BALANCE OF SQUEEGEE
1.
Install the squeegee and tighten up the nuts (H
, Figure 11
), then
connect the vacuum hose (G) to the squeegee.
2.
Adjust the squeegee by squeegee adjusting handle (A, Figure
11).
a)
If there is gap between the ground and middle
section
of rear
squeegee blade (B), adjust the knob (A) in counterclockwise
direction (F) until all sections of the rear squeegee blade make
good contact with the ground, the front blade touches the ground
slightly.
b)
If there is gap between the ground and both end section of rear
blade (C and D), adjust the knob (A) in clockwise direction (E)
until all sections of the rear squeegee blade make good contact
with the ground, the front blade touches the ground slightly.
FILLING SOLUTION TANK
1.
Open the water inlet cover (B, Figure 12).
2.
Fill with water or solution suitable for work performance through
the water inlet with filter.
The solution temperature must not 104F (+40°C).
3.
Do not overfill the tank, refer to water level indicator (H) for the
water volume.
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Insert the ignition key (A, Figure 13) and turn it to "I". Check Batteries status from display screen. If necessary charge the batteries
(see the procedure in Maintenance chapter).
3.
Drive the machine to the working area:
•
By pushing either safety switch (F) to move forward or pressing the safety switch (F) together with the reverse switch (G) to move
backward. The forward speed can be adjusted with the adjuster (H).
4.
Lower the squeegee (I) with the Squeegee lifting/lowering handle (J).
5.
Lower the brush/pad-holder deck (K) by pressing the one button start (L)
6.
Press the solution flow control buttons (O) as necessary, depending on the type of cleaning to be performed.
7.
Start cleaning:
•
Press either safety switch (F) to activate the machine drive. If necessary, the forward speed can be adjusted with the adjuster (H).
WARNING!
Use only low-foam and non-flammable detergents,
intended for automatic scrubber applications.
Figure 12
D
F
A
G
H
Figure 11
