VIPA 900-2H611, Руководство пользователя

Страница: 30 / 72

Chapter 3 Deployment
Manual VIPA TM
3-4 HB39E - TM - RE_900-2H611 - Rev. 10/16
•
Connect your CPU to the Teleservice module via MPI.
•
Switch on the power supply of the CPU and switch the CPU to RUN.
•
Open the Web page of the corresponding Teleservice module.
•
Open with
Configuration
>
I/O server config.
the page for adjusting an
I/O server. Set as I/O server "S73&400".
•
To access the VIPA PLC enter the following parameters:
MPI destination node
: 2 (standard)
Baud rate
: 187500
Reply timeout
: 3000 (standard)
MPI address
: 0 (standard)
Highest MPI station address
: 31 (standard)
Topic A
: enabled
Global device address
: MPI, # (with #: MPI address CPU)
Poll rate
: 2000 MS (standard)
•
To confirm click at [Update config].
Now the CPU may be accessed via the Teleservice module.
In a
Tag
the storage areas of you PLC may be defined. These storage
areas may read and write accessed by the Tag.
•
To establish a Tag open at the Web page the page "Tag setup" and click
at "Create new Tag ...".
•
Enter the following parameters:
Tag name
: Test
Server name
: S73&400
Topic name
: A
Address
: MW0
Type
: Boolean
•
Otherwise leave the standard setting and click at [Add/Update...].
•
Switch with
Main menu
>
View I/O
to the Tag list.
•
Enter a new value for the Tag "Test" and click at [Update]. Now this
value is set and may be transferred to the CPU with clicking to [Update]
in the head line.
•
If the new value is accepted by the CPU, so the communication between
the TM and the CPU is secured.
These steps are more described at the following pages.
Access to the
VIPA PLC
Establish a Tag