VIPA 900-2H611, Руководство пользователя

Страница: 28 / 72

Chapter 3 Deployment
Manual VIPA TM
3-2 HB39E - TM - RE_900-2H611 - Rev. 10/16
Fast introduction
The information in this manual should simplify you the deployment of
remote controlling VIPA PLCs. More information concerning this may be
found in german and english at:
support.ewon.biz
www.ewon-online.de
The Teleservice module is to be supplied with DC 12...24V
±
20%. The
connection is established by a plug. This may be found at the upper side of
the module and has the following allocation:
Pin Name Meaning
2 12-24V DC DC 12 ... 24V ±
20%
2
1
1 GND Ground power supply
For the access to the TM valid IP address parameters are necessary. The
IP addresses are assigned by the network administrator and must be
coordinated with him.
The TM is delivered with the following IP address parameters:
IP address: 10.0.0.53
Subnet mask: 255.255.255.0
To change the IP address parameters the configuration tool "eBuddy" from
VIPA may be used.
Caution!
For every Teleservice module is delivered with the IP address 10.0.0.53
you must not connect more than one new TM at one time.
First commissioning: Connect the new TM with the network, assign TCP/IP
address parameters. Now you may connect the next new TM and so on ...
Connect your PC to your Ethernet-LAN interface (Ethernet 1) of your
Teleservice module. Here either a crossed cable or a switch may be used.
An active link via Ethernet is shown by the Teleservice module with the
green LINK/ACT LED 1 ... 4 upper the Ethernet switch
Important note!
Power supply
IP address
parameters on
delivery
Linking to
Ethernet