Vinyl Express Qe60, Руководство пользователя

Страница: 35 / 116

3 – 7
■
Setting TOOL (cutter blade or pen)
Set the type of pen (cutter blade) to be used.
To display the cutter-pen conditions, either press the (COND.) key when the cutting plotter is in READY
mode, or when the media set lever is lowered and the buffer is in the empty (cleared) status.
Select the setting area (condition number) to be set, and then press the or key to move the sym-
bol to the position shown below.
Press the or key to select “09U,” “15U,” “15B,” or “PEN.” Press the (ENTER) key to confirm
the selection. If other conditions are to be set, press the or key to move the symbol to the param-
eter to be set.
■
Setting OFFSET
This setting adjusts the offset of the cutter blade to suit the blade type used. The tip of the blade mounted
in the cutter-pen plunger is not positioned at the center of the pen, so correction is required. This correction
is referred to as the OFFSET setting. The cutting plotter has been preset with OFFSET values for each cut-
ter-blade type. Selecting “09U,” “15U,” or “15B” for the PEN TYPE setting also sets the appropriate OFF-
SET, allowing fine adjustment within the range of ±5. When the “PEN” setting is selected, the OFFSET
cannot be set.
Press the (COND.) key in READY mode to display the cutter-pen conditions.
Select the setting area (condition number) to be set, and then use the or key to move the sym-
bol to the position shown below.
Use the or key to select the value to be changed in the range of “-5” to “+5.” Press the
(ENTER) key to confirm the selection. If other conditions are to be set, press the or key to move
the symbol to the parameter to be set.
Step
1
Step
2
Step
3
Step
1
Step
2
Step
3
2 0 9 U + 1 2 3 3 0 2
2 0 9 U + 1 2 3 3 0 2