2 – 7
Pressing the
or
key displays “ROLL1 PRESS ENTR”, “ROLL2 PRESS ENTR”, and “SHEET
PRESS ENTR”. Select “ROLL2 PRESS ENTR” or “ROLL1 PRESS ENTR” and then press the
(ENTER) key to confirm. When “ROLL2 PRESS ENTR” is selected, only the medium width is detected.
Select this mode to begin cutting at a point beyond the leading edge. When “ROLL1 PRESS ENTR” is
selected, the leading edge and width of the medium are detected. Select this mode to begin cutting from
the leading edge.
After the medium size has been detected, the pen carriage returns to the origin point and the cutting plotter
awaits cutting data. If the INTERFACE conditions or COMMAND mode have not yet been set, they should
be set. If they have already been set, adjust the cutter pen. Once the cutter pen has been adjusted, the
cutting plotter is ready to perform cutting, so cutting data can be sent from the application software on the
computer.
■
Loading Sheet Media
Lower the media set lever to raise the push rollers.
With the Vinyl Express, position the edges of the medium flush against the guide lines engraved on the
front guide.
Adjust the position of the left- and right-hand push rollers to suit the medium width.
Step
7
Step
8
Step
1
Step
2
Step
3
Guide lines
Media sensor
Flush
Содержание Qe60
