Back
11
Operation
Fitting the pan bar
A single pan bar is supplied and is fitted to either the right or left-hand side of the head onto the
pan bar mounting
(6)
.
To fit the pan bar:
Position the pan bar
(5)
onto the pan bar mounting
(6)
.
Rotate the pan bar clamp
(4)
in a clockwise direction until the pan bar is secured.
A second pan bar can be fitted to the other side of the head if required.
Installing the head onto a tripod
The Vision 3AS and 5AS pan and tilt heads are supplied with an integral 75mm ball mount and
the Vision 8As and 10AS heads have an integral 100 mm ball mount, designed for installation on
a compatible Vinten tripod. Adaptors are available to allow the head to be installed onto tripods or
pedestals fitted with other mountings.
To install the head onto the tripod:
Remove the bowl clamp assembly
(2)
from the head by turning the assembly in a counter-
clockwise direction.
Position the head on the tripod, carefully lowering the head into the tripod bowl.
Using the pan bar to steady the head, refit the bowl clamp assembly
(2)
from below the
tripod bowl, turning the bowl clamp assembly
(2)
in an clockwise direction until the head is
held in position.
Apply the pan brake
(10)
and tilt brake
(12)
by turning the levers in a clockwise direction.
Level the head using the level bubble
(8)
and once level, tighten the bowl clamp assembly
(2)
to secure the head in position. When attempting to level the head in situations where
there is low light, the level bubble can be illuminated by pressing the switch
(8)
located
underneath the level bubble
(9)
. The light will extinguish after approximately 20 seconds.
CAUTION! DO NOT use force on the brake levers. Hand tighten only.
Содержание V4045-4980
Страница 1: ...Vision AS range Operators Guide V4045 4980 Vinten simply perfection pan and tilt heads ...
Страница 2: ...Vision AS range Pan and Tilt Heads Original Instructions Issue 1 ...
Страница 26: ...Back 25 Fig 15 Adjusting the pan and tilt brakes 10 1 12 1 10 2 10 12 2 12 ...
Страница 31: ...Back 30 NOTES ...