11
- If the storage is successful, the interface display will show the subsequent free address that can
be used for a new acquisition.
- If the interface display shows the message
E
repeat the detector channel configuration as
described above.
- If the configuration was successful and correct, the interface will show the subsequent free
address.
- Then continue from point d. of paragraph 9.1.
9.2.2 Detector art. 01728 with separate radio channels
If the detector 01728 has been configured for use with the IN input on a separate channel, follow
the procedure below:
- Press the
PROG
push button to select the channel to save as shown by the LEDs lighting.
LEDs off = Channel 1 (infrared)
Yellow LED lit = Channel 2 (IN)
- Press the
SELECT
push button to confirm your selection.
- If the storage is successful, the interface display will show the subsequent free address that can
be used for a new acquisition.
- If the interface display shows the message
E
repeat the detector channel configuration as
described above.
- If the configuration was successful and correct, the interface will show the subsequent free
address.
- Then continue from point d. of paragraph 9.1.
N.B.: When the auxiliary IN inputs are also enabled in the radio frequency device parameters,
by choosing to set them on separate channels the storage of each of these inputs will occupy a
dedicated channel of the interface 01729; therefore, according to the associated radio channel,
it will be assigned to a related zone in the system.
9.3 Acquisition of art. 01726 and 01731
Below is the general procedure for the acquisition of the detector 01726 (the procedure is similar for detec-
tors 01731 since the push buttons to press have the same wording).
Caution:
Before acquiring the device, you need to set all its parameters as described in the respective
instruction sheets (see instruction sheet for art. 01726 and for art. 01728 for all the configurations of the
devices themselves).
- Set up the radio interface for the acquisition of the device (as specified in points a. and b. of paragraph
9.1).
- Power the Device.
- Press and hold down the
SELECT
push button.
- Press and release the
RESET
push button.
- Release the
SELECT
push button after the LEDs on the device have lit up in sequence.
- Press the
SELECT
push button to confirm your selection.
- If the storage is successful, the interface display will show the subsequent free address that can be used
for a new acquisition.
- If the interface display shows the message
E
repeat the detector channel configuration as described
above.
- If the configuration was successful and correct, the interface will show the subsequent free address.
By-alarm
Operations on radio frequency detectors
