Viking MI 422, Инструкция по эксплуатации

Страница: 100 / 388

0478 131 9923 B - EN
98
Pull the cover (1) apart slightly on the left
and right as illustrated and remove
upwards.
Connect the connector of the
power supply unit (1) to plug
connection (2) of the docking
station circuit board.
Guide the power cable as illustrated
through the strain relief (1), through the
cable duct (2) and to the power supply
unit.
● Install the power supply unit outside the
mowing area, protected from direct
sunlight, humidity and moisture – fasten
to a wall if necessary.
● Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
● Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
Fit the cover (1) onto the
docking station and allow it to
engage – do not pinch any
cables. Then connect the mains
plug.
If necessary, the connector can be
removed (e.g. in order to route the
power cable through a hole in a
wall).
Make sure that the polarity is
correct when attaching the
connector to the power cable.
(
Ö 15.8)
Correct operation of the power
supply unit is only ensured at an
operating temperature between
0° C and 60° C .
The red LED on the docking station
flashes rapidly as long as no
perimeter wire is connected.
(
Ö 12.1)