12
1. Connect/Disconnect
To connect to a
K-1775-IP
shown in the upper left VoIP Phones Discovered window, simply click the unit then click the
“Connect” button. The preprogrammed settings should then fill the tech tool window. When you are finished writing the
programming changes, the disconnect button allows you to disconnect from the unit you have finished programming
and connect to the next unit. Closing the PC programming will also automatically disconnect the unit.
2. Phone Number Database
Clicking on the “Phone Number Database” button
will open a screen allowing you to program all the
Tenants Name’s, Speed Dial Numbers, Primary
and Roll Over phone number’s.
The Speed Dial Number is the 1 to 3 digit number
visitors enter on the
K-1775-IP
’s keypad for the
unit to call the tenant. 3 seconds after the 1 to 3
digit number is entered, the unit will then dial the
Primary Phone Number associated with that
Speed Dial Number. If there is no answer or a
busy signal is detected, the
K-1775-IP
will then
dial the Roll Over Phone Number.
The Primary Phone Number programmed in
Speed Dial location 0 is the number that is dialed
when the “0” key is pressed or when the ”CALL”
button is pressed with no additional digits. A 2nd
Roll Over Number will be dialed when there is no
answer or a busy signal is detected. The
K-1775-
IP
phone is factory set with no Primary or Roll
Over numbers programmed.
Note:
Typical Apartment Applications use the tenants 1 to 3 digit apartment number as the Speed Dial Number. After the
apartment number is entered the unit will then dial the tenant’s phone number.
Programming Features
