6
C. E-20TF-IP / E-20TF-IP-EWP
The
E-20TF-IP
and
E-20TF-IP-EWP
are designed to be surface mounted to a single gang box (not included), a standard
4” x 4” electrical junction box (not included), or directly to a wall or flat sided post.
Caution:
For rough surfaces (ie:
brick, stucco, etc.) additional caulking may be required.
Shipping Weight:
1.5 lbs (0.75 kg)
UP
3.40"
5.50"
1.55"
3.40"
4.50"
1.70" Deep
2.35"
3.30"
Back Panel of the
E-20TF-IP/E-20TF-IP-EWP
Side view of the
E-20TF-IP/E-20TF-IP-EWP
Mount back panel to a wall, a single
gang box or a 4”x4” junction box with
the arrow pointing up.
Note:
For
outdoor applications apply a bead of
caulk between back panel and wall.
Attach the cover to the
base with the two included
screws as shown.
VIKING
©
Front View of the
E-20TF-IP/E-20TF-IP-EWP
To open the speaker box,
remove the two separate screws
from the cover.
VIKING
©
Motion Sensor with LED
B . E-32TF-IP / E-32TF-IP-EWP
3.65"
Wide
Min.
2.84"
Tall Min.
*2.25"
Deep
Min.
"Old Work" Double
Gang Rough-In Box
(Allied Molded 9312 box
shown, not included)
(4) Optional Dry Wall
Screws (not included)
5.0”
Typical
Peel paper liner and adhere gasket
to back of panel, centering over
mounting holes.
Caution:
For rough
surfaces (ie: brick, stucco, etc.)
additional caulking may be required.
Laser Etched Graphics
Motion Sensor with LED
(4) T-10 Torx stainless steel,
flat head, security screws
and drive bit (included)
VIKIN
G
©
The
E-32TF-IP
is designed to be flush mounted to a standard double gang electrical box (minimum dimensions of: 3.65”W x 2.84”H
x 2.25”D).
* CAUTION:
Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the circuit board
causing physical damage.
Dimensions:
Overall: 5” x 5” x 2.25” (127mm x 127mm x 57mm)
E-32TF-IP Faceplate:
14 gauge 316 stainless steel with #4 brushed finish
Shipping Weight:
2.12 lbs (1.0 kg)
Motion Sensor LED :
Motion sensor LED lights steady Blue to help locate the sensor in low light, flashes Green during dialing, then
lights steady Green when answered.
Note:
When mounting outside to rough or uneven surfaces (brick, stucco, etc.) apply a bead of clear silicone caulking around
the top edge and sides of faceplate.
Note:
When European CE compliance is required, mount as shown in a metal enclosure.
Note:
For surface mount installations, use Model
E-30TF-IP / E-30TF-IP-EWP
with
VE-5x5
surface mount box.
