17
If enabled and a busy is detected, the speaker phone will dial the next programmed Speed Dial number. A momentary
press of the call button will dial the first programmed phone number.
Factory Setting:
Enabled
30. Dial Next Number on Busy
31. Send ID Number as
29. Dial Next Number on Ring No Answer
If enabled and a ring-no-answer is detected, the
Entry Phone
will dial the next programmed Speed Dial number after
the programmed amount of rings. A momentary press of the call button will dial the first programmed Speed Dial number.
Factory Setting:
7 (will redial after 7 rings)
The I.D. number can be transmitted as RFC 2833 or as In-Band DTMF.
Factory Setting:
RFC 2833
28. Ring Cadence
The Ring cadence can be programmed to one of 4 different cadences.
Factory Setting:
Normal
Normal Ring
(single ring, 2 seconds on 4 seconds off)
Double Ring
(double ring, 1 second on 0.5 seconds off 1 second on 3.5 seconds off)
Short-Short-Long
(triple ring, 0.5 seconds on 0.5 seconds off 0.5 seconds on 0.5 seconds off 1 second on 3 seconds off)
Short-Long-Short
(triple ring, 0.5 seconds on 0.5 seconds off 1 second on 0.5 seconds off 0.5 seconds on 3 seconds off)
The Inbound Call Mode determines how the
Entry Phone
handles incoming SIP calls. One option is to generate a
loud ring sound through the speaker. The
Entry Phone
can also auto answer a SIP call to transmit a page, control the
relay or listen to transmit audio from the microphone. The last option is the silent monitor mode, which allows callers
to listen to the transmit audio from the microphone. The “secure” options for auto answer require the callers to dial the
access code in order to transmit a page, activate the relay or activate the optional
RC-4A
relays.
Factory Setting:
Auto Answer
Disabled
– Inbound SIP calls are not allowed.
Auto Answer
– Inbound SIP calls are auto answered on the first ring. This can also be used for Silent Monitoring by
changing the speaker mode to ‘OFF/Silent Monitor”, See page 16. For more security use the Auto Answer Secure
Mode.
Auto Answer Secure
– In the “Auto Answer - Secure” mode, the phone will automatically answer an incoming call on
the first ring. The unit will then output 2 beeps but will not go into two-way voice mode. After the 2 beeps are heard,
you will have 10 seconds to enter the pre-programmed 1 - 6 digit Access Code (see section 10 on page 14). When the
correct code in entered, 2 beeps will be heard and the unit will enable the Two-Way Mode (mic and speaker audio).
After the correct Access Code is entered, any of the “Remote Access Operation Commands” can be used (see
Operation, section B on page 21).
Note:
If the wrong Access Code is entered or more than 10 seconds have elapsed,
the phone will output 3 beeps and disconnect.
Ring:
In the “Ring” mode the speaker phone will not automatically answer an incoming call but will output a loud ring
signal out of the speaker in a 2 seconds on, 4 seconds off ring pattern. There are four available ring cadences.
Ring with AGC:
In the “Ring with AGC” mode the speaker phone will not automatically answer an incoming call but
will output a loud ring signal out of the speaker in a 2 seconds on, 4 seconds off ring pattern. The phone will
automatically increase or decrease the ring volume based on background ambient noise. The call can then be answered
by momentarily pressing the call button.
27. Inbound Call Mode
