10
Using Your Induction Warmer
User Buttons
Power button
- Use this button to turn the unit on and off. A green LED will indicate when the unit is
on.
Lock button
- Use this button to prevent users from adjusting settings. Pressing this button three
times will lock the unit. When the unit is locked, the only button that will continue to work is the
Power button. To unlock the unit, press the Lock button three times. The red LED to the right of
the button will indicate when the unit is locked.
Up and Down Arrows
- These buttons allow you to quickly set the temperature.
Alphanumeric display
- Displays holding temperature (Fahrenheit or Celsius) and error code
information
General Operation
Plug the induction warmer into a grounded, single-phase receptacle. Models will run on 100-120VAC
drawing a maximum of 650W. Voltages below 120VAC can result in less than rated power and slower
heating times. This appliance is designed for holding food products only.
This unit is equipped with SmarTag
™
technology, using WIRELESS COMMUNICATOR to provide
precise temperature control.
Note: For proper operation, an independent, dedicated circuit should be used for up to 3 units
installed on a 15A (120VAC) circuit or 4 units installed on a 20A (120VAC) circuit.
To operate this induction warmer unit:
●
Press the Power button to turn the unit on. The green LED next to the power button will
illuminate.
●
Place a Magneeto
™
II trivet on the countertop and position it over top of the unit until the LED
begins flashing and the SmarTag
™
LED illuminates.
●
Place an induction compatible cookware/bakeware on the top of the trivet. To ensure contact wiith
the temperature sensor on the Magneeto
TM
II trivet, the cookware/bakeware must have a flat
bottom. The Pan Detect LED will illuminate.
Make sure the cookware/bakeware is covering the temperature sensor on the Magneeto
™
II, but do not cover the WIRELESS COMMUNICATOR tab.
The unit will start at 80
°
F, or the
last entered temperature. Press the Up and Down Arrows to select desired temperature from the
preset choices.
●
Fahrenheit Settings (150-190 degrees): 150, 160, 175, 190,
●
Celsius Settings (65-85 degrees): 65, 70, 80, 85
●
Once you have chosen your preferred temperature, the unit will begin to heat the
cookware/bakeware. The letter F or C will flash when the cookware is heating. When the
cookware/bakeware has reached the set temperature, the letter F or C will remain solid on the
display.
●
To lock the controls, press the Lock button three times (the red LED to the right of the lock button
will illuminate to indicate the unit is locked). This will prevent temperature settings from being
changed. The Power button will continue to function while locked. To unlock the controls, press
the lock button three more times.
●
When you are finished using the unit, press the Power button. The green Power LED will go out.
Remove the cookware/bakeware from the unit.