VIKING GARDEN iMow MI 632 M, Инструкция по эксплуатации

Страница: 164 / 446

0478 131 9937 B - EN
162
Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
– The robotic mower has been lifted by
the carry handle
Remedy:
– Confirm message with OK
Message:
1170 – No signal
Check wire signal
Possible cause:
– No reception of wire signal during
operation
– The robotic mower is located outside
the mowing area
– Master docking station or electronic
components has/have been replaced
Remedy:
– Check the power supply to the master
docking station
– Check the LED indicator on the master
docking station ( Ö 13.)
– Return the robotic mower to the mowing
area
– Link the robotic mowers and master
docking station ( Ö 9.14)
Message:
1180 – Dock iMow
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
installed incorrectly
Remedy:
– Check the LED on the docking station,
switch on the docking station if
necessary (
Ö 13.)
– Check docking ( Ö 15.7)
– Check funnel-shaped entrance and exit
areas of the corridor ( Ö 12.8)
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– All docking stations occupied
Remedy:
– Check whether the number of robotic
mowers matches the number of
docking stations.
Message:
1200 – Mowing motor fault
see message 0505
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
– Overload at a drive wheel
Remedy:
– Clean the robotic mower ( Ö 16.2)
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required ( Ö 11.7)
Message:
1230 – Docking error
Dock iMow
Possible cause:
– Docking station has been located,
automatic docking not possible
Remedy:
– Check docking, if necessary manually
dock robotic mower ( Ö 15.7)
– Check perimeter wire – ensure correct
routing in the area of the docking station
(
Ö 12.3)
Message:
2000 – Signal problem
Dock iMow
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the master robotic mower in the
docking station – then press OK