VIKING GARDEN iMow MI 632 M, Инструкция по эксплуатации

Страница: 134 / 446

0478 131 9937 B - EN
132
After pressing the OK button, the robotic
mower begins a new learning run along
the perimeter wire.
If it is not docked, it first travels to a
docking station. All the existing starting
points are deleted.
During travel, up to 4 starting points can be
specified by pressing the OK button.
Interrupting the learning procedure:
Manually – by pressing the STOP button.
Automatically – by obstacles at the edge of
the mowing area.
● If the learning run has been interrupted
automatically, correct the position of the
perimeter wire and remove any
obstacles.
● Check the position of the robotic mower
before continuing the learning run. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Ending the learning procedure:
Manually – following an interruption.
Automatically – after docking.
The new starting points are saved
following confirmation with OK.
Starting frequency:
The starting frequency defines how often a
mowing operation is to begin from a
starting point. The default setting is 2 of 10
mowing operations (2/10) at each starting
point.
● Change the starting frequency as
required after learning.
● If the learning procedure has been
aborted prematurely, send the robotic
mower to the docking station via the
iMow app. (
Ö 10.)
Setting starting point 1 to 4
manually
:
Determine the distance of the
starting points from the docking
station and define the starting
frequency.
The
distance corresponds to that
covered from the docking station to
the starting point in metres, measured in a
clockwise direction.
The
starting frequency can be between 0
of 10 mowing operations (0/10) and 10 of
10 mowing operations (10/10).
5 Edge testing:
Prior to the test run, remove all other
robotic mowers that are not to be
used in the test run from the respective
docking stations. Start the test run for
checking correct wire routing.
The "Check installation" step of the
installation assistant is called up on the
relevant machine. (
Ö 9.15)
11.9 TeaM safety
1 Level
2 Link iMow and dock
3 Change PIN code
4 Child lock
5 GPS protect.
1 Level :
Four safety levels can be set;
various locks and safety devices are
activated, depending on the level.
– None :
The robotic mower is unprotected.
– Low :
The anti-theft alarm is active; a PIN
code must be entered in order to link the
robotic mower and docking station, and
to reset the machine to the default
settings.
– Medium :
As "Low", but the time lock is also
active.
The home area of the robotic
mower is defined during the
learning run. If necessary, a home
area already stored in the memory
is extended. (
Ö 14.5)
The docking station is
defined as starting point 0 ;
mowing operations are
started from here as standard.
The starting frequency corresponds
to the calculated residual value of
10 of 10 operations.
To check correct wire routing
around no-go areas, position the
robotic mower in the mowing area
with the front facing the no-go area
and start a test run.
The home area of the robotic
mower and the circumference of
the mowing area are defined during
edge following. This data is
synchronised. If necessary, a home
area already stored in the memory
is extended. (
Ö 14.5)