Viglen EQ100, Руководство пользователя

Страница: 60 / 70

EQ100 Motherboard User Guide V2.0
59
Problem Action
If the hard disk cannot be accessed at all, then check the following:
a) Check that the correct hard disk type is entered in the CMOS RAM by
entering the SETUP routine. Refer to the System manual for further
information.
b) Check that the leads to the hard disk and from the IDE controller are plugged
in fully
Try to boot from the floppy drive in drive A: by placing the Windows start-up disk
in drive A and resetting the system. Once your computer has booted up, you
should then try to access the hard disk by entering C: This is done by entering:
C: , now try entering DIR
Unit does not
boot from hard
disk drive C:
If the hard disk can be accessed through MS-DOS (if performing the above point
did not return an error), but will not boot normally - the system files have been
damaged. Back up all of your data, and reinstall you operating system from
scratch.
Problem Action
Check that the correct type of floppy disk is being used. Remember a 1.44MB
Floppy Disk Drive will not read LS-120 disks.
Try another disk…Sometimes floppy disks may get dust or scratched on the
surfaces, damaging them.
Floppy disk
drive does not
read or write
Check in the CMOS SETUP routine that the correct type of drive has been
selected. (Refer to your System manual).
Problem Action
No input from
the keyboard Check that the keyboard plug is firmly inserted into the socket labelled ‘keyboard’
at the rear of the main system unit. If the ‘Caps Lock’ LED lights up when
pressed, there is an electrical connection.
Problem Action
The mouse is
not being
recognised. The mouse is not plugged in correctly.
Solution: Check mouse plug - make sure the plug is inserted in the correct port.
The plug may become loose after prolonged use.