Viessmann B1HE Series, Инструкция по установке и обслуживанию

Страница: 67 / 128

67
6167 818 - 10
Vitodens 100-W, B1HE/B1KE Combi Installation/Service
Service Menu
Diagnostics and Service Checks
Checking Outputs
(actuator test)
Calling up the service menu
Tap the following buttons:
1.
and OK simultaneously for approx. 4 sec, then
release.
2. Select the required menu section.
Note: Not all menu areas will be available, depending
on the system equipment level.
Note: The boiler automatically switches on the WiFi
access point. Further commissioning steps
according to the instructions in the software
tool used (e.g. “Vitoguide mobile” app)
Note: Tap “ “ to return to the “main service menu”
Leaving the service menu
Tap the following buttons:
“
“ for 4 sec.
Note: The system exits the service menu automatically
after 30 min.
Diagnostics
Checking operating data
Operating data can be checked in various areas.
See “Diagnostics” in the service menu overview.
Operating data on heating circuits with mixing valve
can only be called up if such components are installed
in the system.
Note: If a called up sensor is faulty, “- - -” appears on
the display.
Calling up operating data
Tap the following buttons:
1.
and OK simultaneously for approx. 4 sec,
then release.
2. Use to select “Diagnostics”.
3. OK
4. Use
to select the required group.
5. OK
6. Use
to select the required information.
Service
Active messages
Reset maintenance
Connect with software tool
Diagnostics
Actuator test
System configuration
Message history
Emissions test mode
High limit safety cut-out test
Basic settings
Factory settings
Commissioning assistant
Exit demo mode
Service menu overview
Note: When the actuator test is started, all actuators
are initially disabled and valves moved to their
central position.
Tap the following buttons:
1.
and OK simultaneously for approx. 4 sec,
then release.
2. “Actuator test”
3. OK
4. OK to confirm the prompt.
5. Use
to select the required group.
6. OK
7. Use
to select the actuator.
See the table below.
8. OK
9.
for the required value.
10. OK
Note: The function is active for 30 min.
11. Use to end the Actuator test.