Videotec SW164OSM, Руководство по эксплуатации

Страница: 57 / 135

Page 20 SW164OSM 9901
5.4 Programming SW164OSM matrix
Only the operator that's controlling output #1 can program the matrix.
During Program mode the alarm handling and switching operation are temporarily suspended.
It is necessary to connect a video signal to input 1.
To begin the set-up procedure
Press
P
and, if necessary, insert the set-up password.
Select menu language by pressing
1
until the menu in English is shown.
MAIN MENU
------------------------
1. Language: English
2. Sequence cycle
3. Alarms
4. Titles
5. VCR/Printer
6. Date/Time
7. Other parameters
0. Information
------------------------
PROG.End
To modify sequence cycles
From the main menu, press
2
to access SEQUENCE CYCLES submenu.
Select the sequence to be modified by pressing the corresponding number.
SEQUENCE CYCLE 2.
------------------------
1. Output 1, Day seq.
2. Output 2, Day seq.
3. Output 3, Day seq.
4. Output 4, Day seq.
6. Output 1, Night seq.
7. Output 2, Night seq.
8. Output 3, Night seq.
9. Output 4, Night seq.
------------------------
PROG.End
Each sequence cycle is defined by a maximum of 16
sequence steps indicated by a character from A to P.
Only one of the 16 sequence steps is active and can be
modified (in the example it is step C, marked by two arrows).
Select the active step pressing
U
and
D
.
The steps from H to P are normally not displayed on screen:
the screen will roll up when necessary to display them.
Select the input to be shown pressing a number from 1 to 16
(a 2-second dwell time is automatically proposed).
Modify the dwell time by pressing
E
(one second increase)
and
C
(one second decrease).
To remove a step, enter a time of 0 seconds.
P
confirms the sequence cycle introduced and returns to
the previous menu.
SEQUENCE CHANGE 2.1
------------------------
Output 1 Seq.Day
Step In Sec
A 05 4 ^.Previous
B 07 10 v.Next.
>C 05 4<
D 02 10 ENT.Plus
E -- - CLR.Minus
F -- -
G -- - PROG.End
Sequence step
Input
Seconds
Sequence to be
modified