5
Before you begin
Tools needed to assemble this shower cabin:
Electric screwdriver with a selection of heads, regular screwdrivers, pipe grips, spanners, spirit level, sharp
knife and rubber mallet. Connection of the electrical supply and plumbing may require additional tools.
Do not fully tighten any screw fixings initially during build as this allows the frame to move a little
and aid location of all holes and screws; remember to fully tighten before completion and
subsequent use.
There is a drill bit supplied with the kit, to allow either widening of holes or drilling
new holes which you feel cannot be located during construction.
Water requirements
This shower requires two water supplies (1 x hot and 1 x cold) tested to be between 1 and 3 bar, with
a fl ow rate over 7.5 litres per minute.
NOTE: We recommend water pressures over 2 bar to achieve optimum showering
results.
Gravity Fed systems
If you have a Gravity fed system, then fi tting a Shower Pump
will almost certainly be required
. Fitting
a Shower pump rated over
1.5
bar is necessary as a minimum. Shower pumps MUST be properly
sited, installed and commissioned. Incorrectly installed shower pumps will cause adverse aff ects to
your showering and bathing resulting in pulsing or starting and stopping of the pump. If a pump is
installed, a separate Mains Cold supply must be fi tted and directed to supply the Steam Generator
separately (bypassing the pump).
Isolating Valves
You MUST fit isolation valves to the shower unit on both hot and cold incoming feeds
as it enables
you to turn off the water supply to the shower when not in use (for example going away on
holiday). Additionally isolating valves makes service checks easier than locating the house stop
cock.
Assembly requires two persons.
Electrical
This model requires an electrical supply, this MUST be in the form of an ISOLATED FUSED SPUR. It is
both Illegal and dangerous to fi t this shower to a plug socket in a Bathroom environment. The product
may be supplied with a plug, this is pre-fi tted for testing purposes only and should be removed to
complete the install.
DUE TO THE NATURE OF THIS PRODUCT WE HIGHLY ADVISE THE PURCHASE AND FITTING OF A WATER
SOFTENER
(PLEASE NOTE LIMESCALE BUILD UP MAY CAUSE DAMAGE TO YOUR SHOWER AND WILL NOT BE COVERED
UNDER WARRANTY)
Содержание Essence Range
