Vidalux Essence Range, Инструкция по установке и эксплуатации

Страница: 12 / 38

10
INSTALLING THE FIXED SIDE GLASS PANELS
Remove the SEAL TRIM that is located in the inside
edge of the lower curved rail. It is held in position
by two screws. Remove this trim to help you fi t the
fi xed side glass panels. You will need to re-attach it
after the glass is fi tted.
Locate the two fi xed glass panels. These are
diff erent from the doors as they do NOT have any
holes pre-drilled.
Locate the two U shaped rubber seals.
Take one of the U shaped seals and fi t over one
long edge of the fi xed glass panels. Trim any excess
leaving it running the full length.
Now position this glass panel up to the frame
pushing the long edge of the glass into the
upright of the frame until FULL
Y
bedded into the
frame upright.
This MUST be done from the inside of the frame.
The glass will sit within a lip on the inner surface of
the curved rail both top and bottom.
DO NOT HIT GLASS WITH HARD
OBJECTS TO PUSH INTO THE FRAME.
Fit another 'U' shaped seal to the inner facing edge of
the glass. Ensuring it covers the whole length of the
glass piece. Take the front columns and 'nudge' these
up to the glass to hold the glass inplace with a snug fit
Now both glass panels are fully inserted into the
uprights you can tighten up the four corners of the
silver framework which will not hold the glass in
position.