Vidalux Essence Range, Инструкция по установке и эксплуатации

Страница: 28 / 38

25
Electrical Connections
MAIN POWER
This Steam Shower requires connections to MAINS
ELECTRICITY.
1 x 13amp
The Shower is delivered with a standard 3 pin
plug on the end of the power cord. This is for
TESTING purposes only.
For fi nal fi x this product MUST be connected via
an ISOLATED FUSED SPUR. This work may require
the services of a Qualifi ed Part P Registered
Electrician.
RCD (Residual Current Device)
This shower product also comes pre-fi tted with an
RCD. This device provides safety cut of in case of an
electrical fault.
You MUST ensure all electrical work is
carried out in accordance with current
Legal requirements.
If the Main Board (Consumer Unit) in the property
is already RCD protected you
MUST remove the
one fi tted to this product.
STEAM GENERATOR & ELECTRONIC CONTROL
UNIT
This model has a separate Steam Generator
and Electronic Control Unit. Both parts have a
Data Cable to provide electrical communication
between each part and a Power transfer
connection. Make these connections and ensure
they are secure.
CONNECTING LIGHTS, FAN, OZONE Etc
Each component needs to be connected to the
Electronic Control Unit.
Each component (Fan, Ozone, Speaker etc) has a
thin12v cable with a plug on the end. You will also
see that each cable has a sticker with an Icon to
indicate what it is.
The electronic control unit behind the showers
central tower panel has a large number of cables.
Again, each of these cables has a similar plug
and a label corresponding to those of the Fan,
Ozone, Lights etc. Match each item and make the
connection securely.
AERIAL
Position the Radio aerial wire in a position that
allows the radio to revive the best possible signal.
Note that local interference from Taxis, Ham Radio,
Emergency Service, Hospitals etc may aff ect
reception.
ELECTRONIC CONTROL PANEL
The Shower has an electronic control panel to
allow you to operate and control the steam
production, lights, radio and audio system.
Locate the communication cable coming from the
panel at the rear of the shower and connect it to
the corresponding cable that will be found coming
from the electric control unit. This connection uses
a series of small pins inside,
CARE MUST BE TAKEN
MAKING THIS CONNECTION to not bend the pins.
The plugs are marked with an ARROW to identify
which way they connect.