6.4.2. Resetting the PIN code
If the PIN code is forgotten or lost, it can be easily reset to the default 000000 using the VictronConnect app.
Using VictronConnect
To reset the Bluetooth PIN code:
1. Locate the blue smart charger in the LOCAL page and select the ‘device options’ icon (three vertical dots) on the right side of
the description.
2. Select 'Reset PIN code' from the pop-up prompt.
3. Enter the PUK code and select ‘OK’. The PUK code is located on a label stuck to the side of the
Phoenix Smart IP43
Charger
.
Using the MODE button
To reset the Bluetooth PIN code:
1. Depress and hold the MODE button (on the
Phoenix Smart IP43 Charger
) for 10 seconds.
2. After 10 seconds have elapsed all charge mode LEDs will blink twice to indicate that the PIN code has been reset.
During this procedure:
a. The PIN code is reset to default (000000)
b. Any active Bluetooth connections are disconnected
c. All Bluetooth pairing information is cleared
Subsequently, before attempting to re-connect it’s also necessary to remove/clear the Phoenix Smart IP43
Charger Bluetooth pairing information from any devices (mobile phones or tablets) that were previously
paired.
Phoenix Smart IP43 Charger
Page 28
Setup
