83
Maintenance
Headlight Aim Inspection (LED)
For best results, have an assistant and
perform the inspection in a dimly lit
area.
1. Verify that tire pressure is at
specification. See page 75.
2. Verify that rear suspension ride
height (preload) is at
specification. See page 64.
3. Adjust rear shock air pressure for
weight of rider and cargo. See
page 64.
4. Place a mark or tape on the floor
25 feet (7.6 m) from a wall.
5. Position the motorcycle facing the wall with the center of the front wheel at the mark on
the floor. With the operator and cargo on board, bring the motorcycle to the fully upright
position. Measure the distance from the floor to the center of the headlamp.
6. Place a mark or tape on the wall 3 inches (7.6 cm) below the previous measurement.
7. Move the ignition switch to the ON position and switch the headlamp to low beam.
Observe the headlight aim on the wall. The top edge of the LED low beam must be 3
inches (7.6 cm) below the center of the headlamp and centered straight ahead at 25 feet
(7.6 m). Make any necessary adjustments to headlight aim.
Headlight Aim Adjustment
1. To adjust the headlamp vertically, remove the
headlight bezel by pulling straight outward at the
edges to release the spring clips. Loosen the
adjustment screws evenly to adjust the beam
downward. Tighten the adjustment screws evenly to
adjust the beam upward.
2. To adjust the headlamp horizontally, tighten one
screw and loosen the other equally. The beam will
adjust to the direction of the tighter screw.
3. Verify proper headlight aim. Readjust if necessary.
Headlight Lamp Replacement
High Intensity Discharge (HID) Lamps
High intensity discharge lamps should be handled only by a trained technician wearing the
appropriate protective gear. See the
VICTORY Service Manual
or an authorized VICTORY
dealer.
LED Lamps
LED lamps are not serviceable. If an LED fails to illuminate, the entire assembly must be
replaced. Please see your VICTORY dealer.
25 ft. (7.6 m)
Step 5
(Measure)
3 in.
(7.6 cm)
Step 4
(Mark)
Step 6
(Mark)
Low Beam
Adjustment
Screws
