Victaulic VE414MC, Инструкция по эксплуатации и техническому обслуживанию

Страница: 5 / 64

TM-VE414/415MC_5 REV_D
TM-VE414/415MC / Operating and Maintenance Instructions Manual
3. Disconnect the power cord from the
electrical source before servicing the
tool.
Only authorized personnel should
perform maintenance on the tool. Always
disconnect the power cord from the
electrical source before servicing or
adjusting the tool.
4. Prevent accidental startups.
Place the
power switch in the “OFF” position before
connecting the tool to an electrical source.
WARNING
1. Prevent back injury.
Always use proper
lifting techniques when handling tool
components.
2. Wear proper apparel. Do not wear loose
clothing, jewelry, or anything that can
become entangled in moving parts.
3. Wear protective items when working with
tools. Always wear safety glasses, hardhat,
foot protection, and hearing protection.
4. Keep hands and tools away from grooving
rolls and stabilizer roller during the
grooving operation.
Grooving rolls can
crush or cut fingers and hands.
5. Do not reach inside pipe ends during tool
operation.
Pipe edges can be sharp and
can snag gloves, hands, and shirt sleeves.
6. Operate the tool only with a safety foot
switch. The power drive shall be operated
with a safety foot switch that is located for
easy operator access. Never reach across
moving parts. If the tool does not contain a
safety foot switch, contact Victaulic.
7. Do not over-reach. Maintain proper footing
and balance at all times. Ensure that the
safety foot switch is easily accessible to the
operator.
8. Do not make any modifications to the
tool. Do not remove any safety guarding
or any components that would affect tool
performance.
9. Do not operate the tool at ram speeds
exceeding those specified in this manual.
CAUTION
1. The VE414/415MC tool is designed ONLY
for roll grooving pipe sizes, materials, and
wall thicknesses as designated.
2. Inspect the equipment.
Before using the
tool, check moveable parts for obstructions.
Ensure that tool components are installed
and adjusted in accordance with the
“Tool Setup” section. Ensure that properly
matched roll sets are installed and lubricated.
3. Stay alert. Do not operate the tool if you are
drowsy from medication or fatigue.
4. Keep visitors, trainees, and observers
away from the immediate work area. All
visitors should be kept a safe distance from
the equipment at all times.
5. Keep work areas clean.
Keep the
work area around the tool clear of any
obstructions that could limit movement of
the operator. Clean up any spills.
6. Secure the work, machine, and
accessories.
Ensure that the tool is stable.
Refer to the “Tool Setup” section.
7. Support the work. Support long pipe lengths
with a pipe stand, in accordance with the
“Long Pipe/Tubing Lengths” section.
8. Do not force the tool. Do not force the tool
or accessories to perform any functions
beyond the capabilities described in these
instructions. Do not overload the tool.
9. Maintain tool with care.
Keep the tool
clean at all times to ensure proper and
safe performance. Follow the instructions
for lubricating tool components.
10. Use only Victaulic replacement parts
and accessories
. Use of any other parts
may result in a voided warranty, improper
operation, and hazardous situations. Refer
to the “Parts Ordering Information” and
“Accessories” sections.
11. Do not remove any labels from the tool.
Replace any damaged or worn labels.