8
VE272SFS Roll Grooving Tool
6.
Allow approximately
1
/
2
-inch (13-mm)
clearance from the hex bolts on the back of
the tool to the power drive chuck.
7.
Align the flat portions of the drive shaft
with the chuck jaws by turning the lower roll.
8.
Tighten the chuck. Make sure the jaws
engage with the flats of the drive shaft.
9.
Insert the two adjustable legs completely
into the sockets of the upper leg. Hand-tight-
en the hex bolts.
10.
Insert the top of the leg assembly com-
pletely into the socket under the tool head
assembly. Rotate the assembly until it seats
completely in the socket. The hex head bolts
on the legs should be facing toward the back
of the machine (toward the power drive).
11.
Tighten the hex head bolt with a wrench.
12.
Loosen the hex bolts to release the two
lower legs, allowing them to slide down to the
floor. Turn the leg pads at the bottom until they
are resting flat of the floor.
13.
Level the tool from front to back.
NOTE:
The top of the hydraulic cylinder is a good lo-
cation to measure “level,” as shown above.
TM-VE272SFS 3776 Rev_B.fm Page 8 Friday, December 3, 2004 12:10 PM
Содержание VE272SFS
Страница 2: ......