TOOL SETUP
WARNING
• DO NOT plug the power head into
the electrical source until instructed
otherwise.
Failure to follow this instruction could
result in serious personal injury.
1 . Remove all components from the
packaging, and ensure all necessary items
are included . Refer to the “Receiving the
Tool” section on page 6 .
2 . Select a location for the grooving operation
by taking into consideration the following
factors:
2a . The required power supply (Refer to the
“Power Requirements” section on page
7 and the power drive manufacturer’s
instructions)
2b . Adequate space to handle pipe lengths
2c . A firm and level surface for the power mule
3 . Remove the pallet tie-downs before
attempting to set up and operate the power
mule .
WARNING
• Never attempt to operate a power mule
if it is bolted to a pallet or the floor.
• Failure to follow this instruction could
result in serious personal injury and
damage to the power mule, cut grooving
tool, or pipe.
4 . Insert the power head assembly into the
frame . Align the holes in the power head
assembly with the holes in the frame, as
shown above .
WARNING
• NEVER attempt to operate the power
mule without having the detent pin
installed in the power head assembly/
frame.
• NEVER operate the power head as a
hand-held tool.
Failure to follow these instructions could
result in serious personal injury.
5 . Insert the detent pin into the holes in
the power head assembly/frame .
THIS
DETENT PIN SHALL ALWAYS BE
INSTALLED BEFORE ATTEMPTING TO
OPERATE THE POWER MULE.
TM-PMII_10
REV_C
TM-PMII
/ Operating and Maintenance Instructions Manual
