CAUTION
1. The Power Mule II shall be used ONLY for
driving cut grooving tools, as listed in this
manual.
2. Inspect the equipment.
Before using
the tool, check moveable parts for
obstructions . Ensure that tool components
are installed and adjusted in accordance
with setup instructions .
3. Stay alert.
Do not operate the tool if you
are drowsy from medication or fatigue .
4. Keep visitors, trainees, and observers
away from the immediate work area.
All
visitors shall be kept a safe distance from
the equipment at all times .
5. Keep work areas clean.
Keep the
work area around the tool clear of any
obstructions that could limit movement of
the operator . Clean up any spills .
6. Secure the work, machine, and
accessories.
Verify that the tool is stable .
Refer to the “Tool Setup” section .
7. Support the work.
Support pipe lengths
with a pipe stand or vise .
8. Do not force the tool.
Do not force the tool
or accessories to perform any functions
beyond the capabilities described in these
instructions . Do not overload the tool .
9. Maintain tool with care.
Keep the
tool clean to ensure proper and safe
performance . Follow the instructions for
matching and lubricating tool components,
if applicable .
10. Use only Victaulic replacement parts
and accessories.
Use of any other parts
may result in a voided warranty, improper
operation, and hazardous situations . Refer
to the “Parts Ordering Information” section .
11. Do not remove any labels from the tool.
Replace any damaged or worn labels .
12. OPERATE THE TOOL ON THE HANDLE
SIDE ONLY.
The Power Mule II must be
operated with a safety foot switch that is
located for easy operator access . Never
reach across moving parts . If the power
mule does not contain a safety foot switch,
contact Victaulic .
13. Align the Power Mule II with the cut
groover’s square drive shaft.
Always
position the power mule with 90° to the
cut groover’s square drive shaft . Verify that
there is no binding between the power
mule’s drive head and the cut groover’s
square drive shaft .
14. Do not abuse the safety foot switch cord.
Keep the cord away from heat, oil, and
sharp objects .
15. Always turn off the main power supply
to the tool before servicing the tool.
Only
authorized personnel shall attempt to
perform maintenance on the tool . Always
unplug the power head from the safety foot
switch before servicing or adjusting the
tool .
TM-PMII_5
REV_C
TM-PMII
/ Operating and Maintenance Instructions Manual
