8 . When the grooving operation is complete:
8a . Loosen the two set screws that are located
at the square-drive adapter .
8b . Flip the rotation control switch to the
opposite position .
8c . Momentarily engage the safety foot switch .
8d . Gently pull on the handle of the power
head .
8e . Disengage the power mule from the cut
groover .
8f . Roll the power mule to the RIGHT and out
of the way .
MAINTENANCE
DANGER
• Before performing any
maintenance on the
power mule, disconnect
the power cord from the
electrical source.
Failure to follow these
instructions could result in
death or serious personal
injury.
Check the tire pressure on a daily basis . Verify
that each tire is inflated to 30-psi/207-kPa
maximum .
Refer to the power head manufacturer’s
operating manual for additional maintenance
requirements .
TM-PMII_14
REV_C
TM-PMII
/ Operating and Maintenance Instructions Manual
