45
-
Enable time folder: Check to create a folder in the FTP server; then select the type of folder by day
(daily), Hour (hourly) or Minute (every minute). Note that user must be authorized to create the
folder.
• JPEG Setting
-
Pre-event: A pre-event buffer contains images from the time immediately preceding the event
trigger. These are stored internally in the server. This buffer can be very useful when checking to see
what happened to cause the event trigger.
Enter the desired total length in seconds, minutes or hours, and specify the required image
frequency.
-
Event: Specify the required image frequency (1
˜
2 fps) for the event when it is detected.
-
Post-event: This function is the counterpart to the pre-trigger buffer described above and contains
images from the time immediately after the trigger. Configure as for pre-event.
-
Prefix file name: This name will be used for all the image files saved. If suffixes are also used, the
file name will take the form <prefix>.<suffix>.<extension>.
-
Additional suffix: Add either a date/time suffix or a sequence number, with or without a maximum
value.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.
Alarm Out
When the network camera detects an event, it can control external equipment connected to its alarm output
port.
-
Enable: Select “Enable alarm out” and the output will be activated for as long as the event is active.
Select a Type of NO or NC (Normally Open or Normally Closed).
When the settings are complete, click Save, or click Reset to revert to previously saved settings.
