12
Resetting to the Factory Default Settings
To reset the network camera to the original factory settings, go to the Setup
> System > Maintenance web
page (described in “System
> Maintenance” of User’s Manual) or use the Reset button on the network camera
inside the bottom cap.
•
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings using the Reset
button.
1.
Switch off the network camera by disconnecting the power adapter.
2.
Open the top cap.
3.
Press and hold the Reset button with a straightened paperclip while reconnecting the power.
4.
Keep the Reset button pressed until the Status indicator blinks.
5.
Release the Reset button.
6.
When the Power Indicator changes to Green (may take up to 40 seconds), the process is complete and the
network video camera has been reset.
7.
The network camera resets to factory defaults and restarts after completing the factory reset.
8.
Close the bottom cap tightly to ensure waterproof.
CAUTION: When performing a Factory Reset, you will lose any settings that have been saved. (Default
IP 192.168.1.100)
