Vicon surveyor X971, Инструкция по установке и эксплуатации

Страница: 34 / 53

Installing the Domes
There are three possible domes to be installed, a Mask, a Lower Dome and a Lower Outdoor Dome. The
following is brief description of each Dome. Refer to the Introduction Section of this manual for a detailed
description. Perform Steps 1 and 2 on all installations and proceed to the remaining Steps for a particular
installation.
Mask : 7.25 inch (18.4 cm) diameter black opaque unit which attaches to the base of the
Drive Mechanism magnetically, equipped with a Lanyard, and rotates with the Drive
Mechanism.
Lower Dome : 7.75 inch (19.7 cm) diameter chrome, gold or gray opaque unit that attaches to the
base of the Housing with clips and maintains a fixed position.
Lower Outdoor Dome : 11.3 inch (28.7 cm) diameter clear acrylic plastic unit that attaches to the base of the
Housing with screws and maintains a fixed position.
NOTE : The Accessory Kit comes with tamperproof hardware, in addition to standard hardware, for the
mounting of the Lower Outdoor Dome.
CAUTION : Use care when handling all domes to prevent damage. Refer to the Handling Domes Section
of this manual.
1. Locate the Lanyard inside the Mask. Connect the spring clip on the end of the Lanyard to the mating
latch on the inside of the Drive. Verify that the spring clip is firmly fastened.
2. Place the Mask onto the lower rim of the Drive Mechanism and rotate it until the magnetic latches snap
into place. Verify that the Camera Lens is in sight through the Mask slot.
Figure 24
Exploded View - Indoor Dome Installation
For Indoor Pendant Installations
3. Align the four Lower Dome metal clips with the four
Trim Ring slots and push the Lower Dome upward into
the cutouts until it snaps into place on all four metal
clips.
20
•
Final Assembly X971 Rev 1098 Surveyor Mini Dome System