Vicon surveyor X971, Инструкция по установке и эксплуатации

Страница: 27 / 53

OUTDOOR PENDANT
The Surveyor Outdoor Pendant version mounts in two configurations: Vicon mount or 1.5 inch Pipe mount.
Both configurations use standard 1.5-inch NPT threaded pipe and can be attached to a wall or a ceiling. This
mount is exactly an Indoor Pendant version with an exterior Sunshield and Lower Outdoor Dome for
environmental protection.
The Housing is furnished with an Accessory Kit which includes tamperproof hardware for areas where the
Mini Dome is within easy tampering reach. See Installation Types at the beginning of this section.
Figure 15
Exploded View - Outdoor Pendant
Figure 16
Installation on a 1.5 inch Pipe
Installation Using a Vicon Mount
Vicon mounts are supplied with the correct 1.5-inch NPT
threaded pipe. In addition, the Pipe features a 0.125-
inch (0.3 cm) hole at the mounting end. This hole is used
for Cotter Pin installation as a mechanical safety.
NOTE : Early version mounts did not have the drilled
hole. Contact Vicon for a free warranty
replacement or drill the hole as described above.
1. Install the mount in accordance with the Installation
Manual included with the mount.
2. Install a Set Screw in each hole of the Spacer flush
with the inside surface.
3. Slide the Spacer up to the bottom of the mount and
tighten the Set Screws to hold it in place. Then slide
the O-ring up the Pipe to the bottom of the Spacer.
4. Slide the Sunshield up the Pipe followed by the
Housing. Install the 1.5 inch Lock Nut, tabs facing
upward, up the Pipe and hand tighten to support the
Housing.
5. Rotate the Housing clockwise until it is just touching
the O-ring. Then rotate the Housing one half turn to
assure a firm, watertight seal.
CAUTION: Overtightening the Lock Nut will damage
the Housing and deform the O-ring,
causing the Housing to leak.
6. Insert the Cotter Pin through the Pipe hole from the
outside. Spread the ends of the pin against the Pipe
inner surface. In the rare event that the Lock Nut
loosens, it will stop against the Cotter Pin.
X971 Rev 1098 Surveyor Mini Dome System Housing Installation
•
13