Vicon surveyor X971, Инструкция по установке и эксплуатации

Страница: 28 / 53

Figure 17
Exploded View - Outdoor Pendant 1.5 inch Mount
Installation Using a 1.5-inch Pipe
This installation is similar to the Vicon mount. The
pipe can be fastened to any surface or support
providing sufficient strength and area for the Mini
Dome.
1. Inspect the end of the Pipe and remove any
burrs on the inside diameter.
2. Drill a 0.125-inch (0.3-cm) hole through the
mounting end 0.125 (0.3-cm) above the end.
3. Install a Set Screw in each hole of the Spacer
flush with the inside surface.
4. Slide the Spacer up the pipe a few inches
followed by the O-ring to hold it in place.
5. Slide the Sunshield up the Pipe followed by
the Housing and hold in place. Install the 1.5-
inch Lock Nut, tabs facing upward, to expose
no more then 3/16 inch (0.5 cm) of Pipe below
the nut.
CAUTION: Exposing more than 3/16-inch (0.5
cm) of pipe can cause damage to
wiring and prevent proper seating
and locking of the Drive
Mechanism.
6. Insert the Cotter Pin through the Pipe hole
from the outside. Spread the ends of the pin
against the Pipe inner surface. In the rare
event that the Lock Nut loosens, it will stop
against the Cotter Pin.
Figure 18
Installation on a 1.5 inch Pipe
7. Back the Lock Nut down counter-clockwise
until it rests on the Cotter Pin. Loosen the Set
Screw and lower the Spacer to the top of the
Housing.
8. Press down firmly on the Spacer and tighten
both Set Screws firmly.
9. Rotate the Housing clockwise until it is firmly
tightened against the Spacer.
14
•
Housing Installation X971 Rev 1098 Surveyor Mini Dome System