Vicon surveyor X971, Инструкция по установке и эксплуатации

Страница: 23 / 53

Installation Using a 1.5-inch Pipe
This installation is similar to the Vicon mount. The pipe
can be fastened to any surface or support providing
sufficient strength and area for the Mini Dome.
1. Inspect the end of the pipe and remove any burrs on
the inside diameter.
2. Drill a 0.125-inch (0.3-cm) hole through the mounting
end 0.125 (0.3-cm) above the end.
3. Install a Set Screw in each hole of the Spacer flush
with the inside surface.
4. Slide the Spacer up the pipe a few inches and tighten
one Set Screw just enough to secure it.
CAUTION: Exposing more than 3/16 inch (0.5 cm) of
threads from the bottom of the Lock Nut
can cause damage to the wiring and
prevent the Drive Mechanism from
seating and locking properly.
Figure 7
Exploded view - Indoor Pendant and Pipe Mount
Figure 8
Installation on a 1.5-inch Pipe
5. Slide the Housing up the pipe followed by the Lock
Nut screwed onto the threads three full turns (no
more than 3/16-inch) and lower the Housing to rest
on the Lock Nut.
6. Insert the Cotter Pin through the pipe hole from the
outside. Spread the ends of the pin against the pipe
inner surface. In the rare event that the nut loosens,
it will stop against the Cotter Pin.
7. Back the Lock Nut down counter-clockwise until it
rests on the Cotter Pin. Loosen the Set Screw and
lower the Spacer to the top of the Housing.
8. Press down firmly on the Spacer and tighten both Set
Screws firmly.
9. Rotate the Housing clockwise until it is firmly
tightened against the Spacer.
X971 Rev 1098 Surveyor Mini Dome System Housing Installation
•
9