Viavi Xgig1000, Руководство по оборудованию

Страница: 102 / 172

Chapter 2 Xgig1000 System Setup
Setup Instructions
Page 86 Xgig1000 Hardware Guide March 2017
Setup Instructions
To prepare the Xgig1000 chassis for use, follow one of the three paths below depending
on your environment:
PATH 1: Setting Up the Xgig1000 Chassis in a DHCP Network
Follow the steps below to use the Xgig1000 chassis in a DHCP-configured network.
Connect the Xgig1000 chassis to the network and verify that the chassis can be accessed
from another node on the network.
The default name for the Xgig1000 chassis is “XGIG1K” followed by the eight-digit serial
number; for example,
XGIG1K78234335 . The serial number is located on the bottom of
the Xgig1000 chassis.
1 Use the RJ-45 Ethernet straight-through cable to attach the Xgig to the network.
The Ethernet connection is required for management of the Xgig1000 chassis
through application software and for configuration through the Xgig Web Utility.
2 Plug in the Xgig1000 chassis. Attach the female end of the power cord to the
Xgig1000 chassis power receptacle and the male end into an appropriate power
source.
3 Turn the chassis on using the power switch on the back of the chassis. If the chassis
does not have a power switch on the back, skip this step.
4 Press the Front Panel Reset button to initiate the power on sequence.
5 From the PC attached to the network, launch the browser. Access the Xgig1000
chassis using the default name as the URL. For example,
http://XGIG1K78234335 .
If the operation is successful, you will see the screen asking for the user name and
password to access the Xgig Web Utility. The default user name is “
JDSU ” and the default
password is “ JDSUsnt ”.
NOTE
The Xgig1000 chassis comes ready-to-use in a DHCP-configured network. This is the
easiest way to setup the Xgig1000 chassis. Follow Path 1 unless you are required to
setup the system differently.
WARNING
Serious errors may occur if the Xgig1000 chassis is not shutdown properly. If you have
a problem during setup and need to shutdown, follow either shutdown procedure
in
“Xgig1000 Chassis Shutdown Sequence” on page 99 before removing power to
the chassis.