Viadrus HERCULES ECO, Руководство по эксплуатации и установке

Страница: 25 / 40

25
1. Place the fuel tank (1) on the desired location next to the boiler (see Fig.no.7). Push the screw conveyor
of the fuel tank (7) through the hole in the side of fuel tank and secure it with a pendant chainlet (3).
Insert the elbow pipe (8) into the hole
∅
76 mm in the burner and insert an adapter (reduction) (9) with a
wider side into the elbow pipe. Connect the adapter (reduction) with worm conveyor of fuel reservoir (7)
through a transport hose (4). Secure both ends of the transport hose (4) with hose clamps.
ATTENTION! The fuel reservoir screw conveyor must be mounted in a way making sure that there
is a sufficient gradient of flex hose against the pellets falling freely on the combustion chamber
screw conveyor without stopping the hoses with pellets.
2. Mount the combustion air ventilator on the combustion chamber sleeve with the choke valve screwed
ahead on the ventilator suction side.
3. Carry out the electrical interconnection of motors and fan with the controller; see the wiring diagrams
(Fig. no. 21 and see chap. 8.1).
6.5 Boiler shells and regulator assembly
1. Left side panel of the shell
2. Panel pin
3. Washer 5,3
4. Nut M10
5. Insulation of the side panel of the shell
6. Bushing HEYCO
7. Rod
8. Washer 10,5
9. Lever of the control mechanism
10. Pin 3x26
11. Split pin 2,5x32 12. Sticker for alarm of the smoke damper
13. Right side panel of the shell
14. Insulation of the side panel of the shell
15. Blind flange 15,9
16. Upper panel of the shell
17. Insulation of the upper panel of the shell
18. Thermomanometer
19. Controller RKU
20. Bolt ST4,8x13
21. Bakelite ball for draw bar
Fig.no.17 Boiler shell