E
nglish
SPM32
23
10. Start-up of the equipment
11. Information for the use of the power pack and battery charger
Insert the battery and push until the safety switch clicks as shown
in the illustration.
For safety reasons, the battery shall only then be inserted, when
a corresponding pressing jaw is installed.
The press tool must never be operated without a pressing jaw.
The battery charger is designed for 230 V CA 50-60 Hz. The new batteries are provided
partially charged and must be charged before using the tool the first time. In order to
recharge the battery, the charger plug must be inserted into a wall socket and the power
pack must be placed in the battery charger. A 2.6 Ah power pack can be recharged in
approximately 45 minutes. The status of the charge for the power pack is indicated by
the luminous diode on the battery charger.
A
Caution:
When the power pack is not being used keep it away from paper clips,
coins, keys, nails, screws and other small metal objects which could act as contact
bridges. A short circuit between the battery contacts could cause combustion or fires.
A
Caution:
Do not charge the power pack in the presence of easily inflammable gas
or materials. After charging, remove the battery charger plug from the wall socket.
Do not disassemble the battery charger.
A
Caution:
In case of longer storage periods the state of charge of the battery must
be checked periodically. The optimum charge is between 50% and 80%. The pow-
er packs should be recharged every 12 months at most to avoid depth discharge
which could cause damage.
A
Caution:
Discharged power packs should not be stored for periods of more than one
month to avoid depth discharge which could destroy the battery.
